Skip to main content

Programas de test

En el repositorio https://github.com/arduino/arduino-alvik-mpy/tree/main/examples podemos encontrar ejemplos para ver el uso de los diferentes sensores y actuadores, por ejemplo

Sensor name Part name Test program name
RGB Color detection APDS 9660 read_color_sensor.py
ToF 8x8 Array - up to 350 cm LSM6DSOX read_tof.py
IMU - 6 degree VL53L7CX read_imu.py
3x Line follower custom made line_follower.py
7x Touch sensor AT42QT2120 read_touch.py
Actuator name Part name Test program name
Geared motors w/ encoder GM12-N20VA-08255-150-EN wheels_positions.py
RGB LEDs RGB LEDs leds_settings.py
Detector de color

Modificación del read_color_sensor.py

from arduino_alvik import ArduinoAlvik
from time import sleep_ms
import sys

alvik = ArduinoAlvik()
alvik.begin()

while True:
    try:
        r, g, b = alvik.get_color()
        h, s, v = alvik.get_color('hsv')
        print(f'RED: {r}, Green: {g}, Blue: {b}, HUE: {h}, SAT: {s}, VAL: {v}')
        print(f'COLOR LABEL:')
        print ({alvik.get_color_label()})
        sleep_ms(1000)
    except KeyboardInterrupt as e:
        print('over')
        alvik.stop()
        sys.exit()

Detector TOF

Si ejecutamos read_tof.py

from arduino_alvik import ArduinoAlvik
from time import sleep_ms
import sys

alvik = ArduinoAlvik()
alvik.begin()

while True:
    try:
        L, CL, C, CR, R = alvik.get_distance()
        T = alvik.get_distance_top()
        B = alvik.get_distance_bottom()
        print(f'T: {T} | B: {B} | L: {L} | CL: {CL} | C: {C} | CR: {CR} | R: {R}')
        sleep_ms(100)
    except KeyboardInterrupt as e:
        print('over')
        alvik.stop()
        sys.exit()

Detecta hasta los obstáculos por arriba

Giro

Si ejecutamos read_imu.py

from arduino_alvik import ArduinoAlvik
from time import sleep_ms
import sys

alvik = ArduinoAlvik()
alvik.begin()

while True:
    try:
        ax, ay, az = alvik.get_accelerations()
        gx, gy, gz = alvik.get_gyros()
        print(f'ax: {ax}, ay: {ay}, az: {az}, gx: {gx}, gy: {gy}, gz: {gz}')
        sleep_ms(100)
    except KeyboardInterrupt as e:
        print('over')
        alvik.stop()
        sys.exit()

Vemos como el eje x cambia de -1  0  a 1 según la posición

No Comments
Back to top